Skip to content

Red warning light on? Stop safely first, then check what it means.

Step-by-step DIY

How to Rotate Your Tyres

6 stepsTime: 45–60 minutesModerate

Rotating tyres means moving them between positions so they wear evenly. Use the pattern your handbook gives: commonly fronts straight back and rears crossed to the front on front-wheel-drive cars, and the reverse on rear-wheel drive. Directional tyres only move front to back on the same side.

Gloved hands topping up blue washer fluid in an open engine bay during a DIY check

Step by step

  1. 1

    Check the pattern and tyres

    Confirm the pattern in your handbook and look for any directional arrows on the sidewalls.

  2. 2

    Loosen the nuts on the ground

    Crack each nut loose before lifting.

  3. 3

    Lift safely

    Jack at the marked points and support the car on axle stands. Never work under a car held only by a jack.

  4. 4

    Move the wheels

    Swap positions following the pattern.

  5. 5

    Tighten in a star pattern

    Snug the nuts, lower the car, then torque to specification.

  6. 6

    Set pressures and reset TPMS

    Inflate to the placard figure and relearn TPMS if your car needs it.

Common mistakes to avoid

  • Swapping directional tyres side to side
  • Forgetting to re-torque nuts
  • Ignoring uneven wear that points to alignment problems

Not comfortable doing it yourself?

A local garage can do this quickly. Compare nearby options.

Find a garage

Frequently asked questions

How often should I rotate tyres?

Many makers suggest roughly every 5,000–8,000 miles; check your handbook.

Should the spare be included?

Only if it's a full-size matching tyre and your handbook includes it.

Related guides

General information, not a diagnosis. If a warning light is red, the car drives abnormally or you're unsure, stop safely and have a qualified technician inspect the vehicle.