Skip to content

Red warning light on? Stop safely first, then check what it means.

Step-by-step DIY

How to Change a Flat Tyre Safely

6 stepsTime: 20–30 minutesModerate

Stop somewhere safe and level, apply the handbrake and hazards, loosen the wheel nuts slightly, jack the car at the marked point, remove the wheel, fit the spare, hand-tighten, lower the car, then tighten the nuts in a star pattern.

Gloved hands topping up blue washer fluid in an open engine bay during a DIY check

Step by step

  1. 1

    Get to safety

    Pull well off the road on firm, level ground. Hazards on, passengers out and away from traffic.

  2. 2

    Secure the car

    Handbrake on, in Park or first gear. Chock the opposite wheel if you can.

  3. 3

    Loosen the nuts

    With the wheel on the ground, loosen each nut half a turn anticlockwise.

  4. 4

    Jack at the correct point

    Use the jacking point shown in the handbook. Lift until the tyre clears the ground.

  5. 5

    Swap the wheel

    Remove the nuts and wheel, fit the spare, and hand-tighten the nuts.

  6. 6

    Lower and tighten

    Lower the car, then tighten in a star pattern. Check torque at a tyre shop soon.

Common mistakes to avoid

  • Jacking before loosening nuts
  • Using the wrong jacking point
  • Driving fast on a space-saver spare
  • Forgetting the locking nut key

Not comfortable doing it yourself?

A local garage can do this quickly. Compare nearby options.

Find a garage

Frequently asked questions

How fast can I drive on a space-saver?

Usually limited, often 50 mph (80 km/h). Check the label on the wheel.

What if my car has no spare?

Use the repair kit or call roadside assistance.

Should I retighten the nuts later?

Yes. Have the torque checked after a short distance.

Related guides

General information, not a diagnosis. If a warning light is red, the car drives abnormally or you're unsure, stop safely and have a qualified technician inspect the vehicle.