Skip to content

Red warning light on? Stop safely first, then check what it means.

Step-by-step DIY

How to Clean Car Battery Terminals

6 stepsTime: 15 minutesEasy

Switch off, disconnect the negative clamp first then the positive. Scrub corrosion off with a baking soda and water solution and a wire brush, rinse lightly, dry, then reconnect positive first and negative last.

Gloved hands topping up blue washer fluid in an open engine bay during a DIY check

Step by step

  1. 1

    Prepare safely

    Engine off, keys out, gloves and eye protection on.

  2. 2

    Disconnect negative first

    Loosen and remove the black (−) clamp, then the red (+).

  3. 3

    Neutralise corrosion

    Apply a baking soda and water solution. It will fizz.

  4. 4

    Scrub

    Brush the posts and inside the clamps until shiny.

  5. 5

    Rinse and dry

    Wipe with a damp rag, then dry.

  6. 6

    Reconnect positive first

    Fit and tighten red (+), then black (−). Apply a thin protective coat.

Common mistakes to avoid

  • Removing positive first
  • Letting solution into battery vents
  • Leaving clamps loose

Not comfortable doing it yourself?

A local garage can do this quickly. Compare nearby options.

Find a garage

Frequently asked questions

What causes battery corrosion?

Gases venting from the battery reacting around the terminals, often worse with overcharging or age.

Will cleaning fix a no-start?

If corrosion was the cause, yes.

Do I need to reset anything after?

Some cars need radio codes, window or clock resets. Check the handbook.

Related guides

General information, not a diagnosis. If a warning light is red, the car drives abnormally or you're unsure, stop safely and have a qualified technician inspect the vehicle.