Skip to content

Red warning light on? Stop safely first, then check what it means.

Step-by-step DIY

How to Change Engine Oil and Filter

6 stepsTime: 45–75 minutesModerate

Warm the engine slightly, support the car safely, drain the old oil, fit a new filter and drain-plug washer, refill with the grade and quantity in the handbook, then check the level and look for leaks. Recycle the old oil properly.

How to Change Engine Oil and Filter

Step by step

  1. 1

    Warm up briefly

    A few minutes of running helps oil drain. Hot oil burns: let it cool slightly.

  2. 2

    Lift safely

    Use ramps or axle stands on level ground.

  3. 3

    Drain the oil

    Remove the plug with the pan underneath; let it drain fully.

  4. 4

    Replace the filter

    Remove the old filter, check its gasket came off, oil the new seal and hand-tighten as specified.

  5. 5

    Refit the plug

    Use a new washer and tighten to specification.

  6. 6

    Refill and check

    Add oil, run briefly, wait, then check the dipstick and look for leaks. Reset the service light.

Common mistakes to avoid

  • Double gasket on the filter
  • Overfilling
  • Over-tightening the drain plug
  • Wrong oil grade

Not comfortable doing it yourself?

A local garage can do this quickly. Compare nearby options.

Find a garage

Frequently asked questions

How much oil does my car take?

Check the handbook; capacities vary widely.

Can I skip the filter?

It's not recommended. Change both together.

Related guides

General information, not a diagnosis. If a warning light is red, the car drives abnormally or you're unsure, stop safely and have a qualified technician inspect the vehicle.