
Car Pulls When Accelerating: Causes
Quick answer
Some pull under hard acceleration is normal in powerful front-wheel-drive cars (torque steer). Worn engine mounts, control-arm bushes, uneven tyres or alignment problems make it worse.
- Topic
- Suspension & Steering
- Sections
- 5
- Reading time
- 1 min
- Applies to
- All regions

If your car pulls when accelerating, the most common reason in front-wheel-drive cars is torque steer: unequal forces through the driveshafts tug the steering under hard acceleration. Worn engine mounts, control-arm bushes, mismatched or under-inflated tyres and alignment problems make it worse.
Is it safe to drive?
Mild torque steer is normal in powerful FWD cars. A new or strong pull, or one that comes with clunks, should be checked.
Causes at a glance
| Clue | Likely cause |
|---|---|
| Only under hard acceleration, FWD | Torque steer (normal-ish) |
| Clunk on take-off | Engine mounts |
| Pull changes when lifting off | Worn control-arm bushes |
| Pull all the time | Alignment or tyre pressure |
| After new tyres | Tyre conicity |
Check these in order
- Check tyre pressures and that tyres match.
- Note when it happens: hard acceleration only, or always?
- Listen for clunks pulling away.
- Book an alignment and suspension check.
What a mechanic will do
They'll inspect mounts and bushes, swap tyres side to side to test, and check alignment.
Related guides
Frequently asked questions
What is torque steer?
A tug on the steering when front-wheel-drive cars accelerate hard, caused by unequal driveshaft angles and forces.
Does it happen in rear-wheel drive?
Much less, because the front wheels only steer.
Tools that can help
Need a mechanic?
Find rated garages near you by city, ZIP code or postcode, with directions.
About this guide
Written by Editorial Team using manufacturer documentation, government road-safety guidance and motoring-organisation advice. It explains likely causes and safe checks. It is not a diagnosis. How we write and check guides.
More suspension & steering guides
Suspension & SteeringCar Suspension and Steering: The Complete Guide to Parts, Problems and Checks
Suspension keeps the tyres pressed to the road and the ride controlled; steering points the wheels where you want to go. This guide explains every main part, the noises and handling changes that signal wear, the checks you can do, and when to see a professional.
Updated November 22, 2026Read
Suspension & SteeringGrinding Noise When Turning: Causes
Grinding while turning often means a failing wheel bearing, worn brake pads, a bent brake dust shield rubbing the disc, or a CV joint that has lost its grease.
Updated November 22, 2026Read
Suspension & SteeringSqueaking Noise Over Bumps: Causes
Squeaks over bumps usually come from rubber suspension bushes drying out, worn ball joints, strut top mounts or anti-roll bar bushes. Cold weather makes them worse.
Updated November 22, 2026Read