Skip to content

Red warning light on? Stop safely first, then check what it means.

Starting & Battery

How to Jump Start a Car Safely, Step by Step

By Editorial TeamPublished Updated 2 min read

Part of: Car Won't Start: Find the Cause · Car Battery Problems: Dead, Weak or Draining

Quick answer

Connect red to the flat battery's positive, red to the good battery's positive, black to the good battery's negative, then black to bare metal on the dead car, away from the battery.

Topic
Starting & Battery
Sections
8
Reading time
2 min
Applies to
All regions
Car battery with jump leads attached and a multimeter testing the voltage
This guide is general information, not a diagnosis. If a warning light is red, the car drives abnormally, or you're unsure, stop safely and have a qualified technician inspect the vehicle.

To jump start a car, park the cars close without touching, switch both off, and connect the leads in this order: red to the flat battery's positive (+), red to the good battery's positive, black to the good battery's negative (−), then black to a bare metal earth point on the dead car, away from the battery. Start the good car, wait a few minutes, then start the flat one.

Before you start

  • Check the flat battery isn't cracked, leaking, swollen or frozen. If it is, don't jump it.
  • Read the handbook. Some cars have remote jump points under the bonnet.
  • Wear eye protection if you have it. No smoking or flames nearby.

The connection order

Step Connect Why
1 Red clamp to flat battery + Positive first
2 Red clamp to good battery + Completes positive side
3 Black clamp to good battery − Earth on donor
4 Black clamp to bare metal on dead car Final spark away from battery

Starting the cars

  1. Start the donor car and let it run for a few minutes.
  2. Try to start the dead car. Crank for no more than about 10 seconds at a time.
  3. If it doesn't start, wait a few minutes and try again, checking the clamps bite.
  4. Once it runs, remove the leads in reverse order: black from dead car, black from donor, red from donor, red from dead car.

Using a jump starter pack

Portable lithium packs work the same way: red to positive, black to an earth point (or negative), then switch the pack on. Follow its instructions.

After the jump

Drive for at least 30 minutes, or charge the battery. Then have the battery and alternator tested, because a battery that went flat once often does again.

If it won't start

See car won't start even with a jump.

Regional notes

Roadside services such as AAA, CAA, the AA, the RAC, NRMA and RACV can jump start and test your battery for you.

Frequently asked questions

Why connect the last black clamp to metal, not the battery?

The final connection can spark. Making it away from the battery reduces the risk of igniting hydrogen gas the battery can release.

How long should I drive after a jump start?

At least 30 minutes of normal driving helps recharge, but a deeply flat battery may need a proper charger. Have the battery tested.

Can I jump start a hybrid or EV?

Many have a 12 V battery that can be jumped from marked points. Follow the handbook exactly and never touch orange high-voltage cables.

Tools that can help

Need a mechanic?

Find rated garages near you by city, ZIP code or postcode, with directions.

Find a garage

About this guide

Written by Editorial Team using manufacturer documentation, government road-safety guidance and motoring-organisation advice. It explains likely causes and safe checks. It is not a diagnosis. How we write and check guides.

More starting & battery guides